= Long presence on the market: the profile at Polish facilities has been operating since 2002, and the development of form and size has been made in the 80s in France, Spain and Greece.

АЛЮМІНІЄВИЙ УНІВЕРСАЛЬНИЙ ПРОФІЛЬ
Найбільш популярний тип кріплення плівки, який складається з високоякісного алюмінієвого профілю і кріпильного елементу у вигляді 2
= plastic profiles. Used to fasten a single and double film in straight and curvilinear sections.
Advantages
Versatility: Suitable for fastening and connection of a single and double film, both in straight areas and in curvilinear.
= Strength: profile is resistant to damage when bending, with proper installation guarantees a strong attachment of the film to the structure.
= The possibility of repair of the film: the use of the profile for fastening makes it possible to multiply and dismantle the film, which guarantees the possibility of repairing poorly fixed or another installation of the film. (// tractor-service.com)
Many years of use: a profile consists of a material that is not amenable to rapid corrosion or wear. The recommended period of replacement of plastic for new 6-10 years (depending on the place of mounting, etc.)
Довга присутність на ринку: профіль на польських об'єктах працює вже з 2002 року, а розробка форми і розмірів була зроблена в 80-тих у Франції, Іспанії та Греції.
= Installation method
It is recommended to attach the profile to the supporting element with galvanized screws M6, the mounting every40-50cm. Recommended load -bearing elements: profile 30x30, 40x30, 40x20, thick flat steel sheets, pipes. Fastening with screws can cause problems (possibility of damage during strong winds).
= After installing the profile on the structure, you can proceed with the lining of the object with a film. It is necessary to put a film between aluminum and plastic (tint) and fix
plastic (wedge) profile. The trough should be put at an angle of 45%to block the film and H7E damage the profile itself until accurately fixing the plastic profile in the aluminum /steel. Thanks to this, the free end of the film has the opportunity to get into the profile.
It is necessary to avoid tension of the film (first by blocking the plastic clips the free end of the film) due to the possible incision of it inside the profile. It is recommended to clog the wedge with a rubber hammer .|| 165