Розпилювач ID-120-05, пластик (6ID.487.56.00, ID120-05, ID3120-05, 120-05), Кіровоградська обл.

The design of the ID sprayer has two air-absorbing holes through which the working solution is enriched with air: thanks to this, the drops become large and heavy and less prone to erosion and evaporation due to their volume andweight.

When hitting the target surface, the air-filled drop breaks into smaller drops, which allows you to cover most of the plants.

ID sprayers can be used for processing in windy weather (more than 5 m/s) and at higher speeds (up to 24 and more km/h)
Size: 01 - 10

Drop size: from extremely large to medium.

Cutting torch angle: 120°(//tractor-service.com)

Seat: 10 mm

Material - plastic

90% wear reduction ID-120-025 to 06
The extended injector helps to reduce the level of wear even at an increased pressure of 8 bar.
The ability to carry out treatments under unfavorable conditions, when the work of other sprayers must be stopped.
Covers a wide range of work due to a wide range of operating modes at pressures from 2 to 8 bar: selection of the operating mode according to the speed and rate of pouring - and all this in one standard size!
very good coverage density and penetration into the stem