Секция культиватора КРН, секція КРН від виробника, КРН от производителя из г. Днепр, Дніпропетровська обл.

landlanna from the catwalks with the pursuit This is not permanent and hanging out of different factors. Turn over the phone.
Цена не постоянна и зависит от разных факторов. Спрашивайте по телефону.

Structural features of the Secius of KRN of the New Observer:

1. In the Prachipnikov, the backlash was installed 180503 (62203). The rubbish is filled with rubber cuts (plastic plots) and reliably squeezed from the fall of the poll 2. In the housings of the rubbers installed tactnits (olives);

2. В корпусах подшипников установлены тавотницы (масленки);

3. Корпуса подшипников защищены металлическими пыльниками;

= 4. The housing of the supporting referenceколеса drawn by omentums and metallic dumplings;

= 5. In the spring details (prisms, pads, tie wine, brackets, rods of the holder) are covered with anti -corrosion ema 6. For the sectorals installed chromium brackets, holes, springs and methishes;

6. На секции установлены хромированные скобы, пыльники, пружины и метизы;

= 7. Izdelie has a powder paint high -speed;

8. The disks of the support wheel of the section are covered with a hammer in a glow. Such a cover does not only embrace the corrosion, but is a personally standing for mechanical re -regulation.

= - KRN section without working bodies,
- KRN section with working bodies. (// tractor-service.com)

We reserve the right to change the value both in the larger and the smaller side, due to the volume of order, the form of calculation and balances on composition=. Accurate supply conditions will be reported by telephone on the day of your appeal.

We also offer an enhanced upgraded cultivator hinged KRN, which is aggregated with tractors of 60 horsepower.

= Characteristics of CRN cultivator:
- frame, bar 140x140mm., 6 mm thick;
- Транспортний пристрій: передній кронштейн (товщина 12 мм), що кріпиться до причіпного механізму 6 болтами М20 підвищеного класу міцності 8.8. Модернізований причіпний пристрій.
Reinforced racks of support wheels (profile 80x60 mm, wall 6 mm). The same racks together with wheels are rearranged to the working position. In the working position are attached to the original brackets. The crossing of the transport device is also reinforced (profile 80x80 mm, wall 6 mm). The racks of the support wheels both in the transport and in the working position are fixed with fingers with threaded fixation. Cultivator wheels are enlarged to 6.00x12 (standard 5.00x10), with increased permissible load;
= - cultivator is equipped with colored reflective alarm (to improve safety when moving public roads).

= To tractors with a power of 60 horsepower:
- КРН-4,2 стандарт,
- KRN-4,2 standard, with a transport device,
- КРН-4,2 стандарт, з транспортним пристроєм та системою внесення добрив,

До тракторів потужністю від 80 кінських сил:
- КРН-5,6 стандарт,
- KRN-5,6 standard, with transport device,
- KRN-5,6 Standard, with a transport device and fertilizer application system,
- КРН-5,6 посилений, модернізований, з транспортним пристроєм,
- KRN-5,6 reinforced, upgraded, with a vehicle and fertilizer application system,

= Transport device to KRN cultivator can be purchased separately.