I will sell calibration machine ISM-40, Kharkiv region.

ISM-40 is another open type machine from our model range. It can work on ZAV, elevators or in autonomous mode. Our machines are very easy to use. A small control panel with a minimum number of buttons and levers will allow you not to get confused and master our machine in a matter of seconds. There is also an electronic dashboard on the control panel that shows the engine speed. Why it is needed: For example, you work with several cultures and every time you start a separator or change from culture to culture you need to set up the machine again. With this electronic panel, this problem is solved. You only need to adjust our separator to the crop once and write down the motor speed reading in your notebook so that the next time you work with this crop, you can immediately start with the value you wrote down, and not waste a few precious minutes on the adjustment. This is very important when there is a season and a lot of work, then a person appreciates every minute. Of course, it cannot be said that if you cleanedgrain once, then at the same engine speed you will clean the next batch (much depends on the weeds and the humidity of the product), but you will know from which initial indicator you should start work and with the help of the engine speed control knob you will adjust the cleaning or calibration of your material.